Skip to content

CW308T-STM32F-SOCKET

The CW308-STM32F-SOCKET board is the perfect target for testing fault injection against TQFP-64 STM32F/STM32L microcontrollers. Thanks to pin compatablity (mostly) between various devices, this single board supports multiple STM32F/STM32L microcontrollers.

These boards do not ship with any microcontroller, but use a 64-pin TQFP socket.

Specifications

Feature Notes/Range
Target Device STM32F
Target Architecture Arm Cortex M0, M3, M4
Hardware Crypto Possible
Programmer STM32F Serial Bootloader, JTAG, SWD
Availability Starter kits, Standalone
Status Released

Supported Devices

The STM32F board supports several STM32F devices in the TQFP-64 package. The switch needs to be set in either the "A" or "B" position to select appropriate VCC supply for the different series. The following table summarizes examples of suitable devices, in the following list these devices are available in fixed boards as well.

STM32F Series Package Device Hardware AES Tested Jumper Flash SRAM **NAE P/N for Fixed PCB **
F0 TQFP-64 STM32F071RBT6 No Yes B 128KB 16KB NAE-CW308T-STM32F0
F1 TQFP-64 STM32F100RBT6B No Yes B 128KB 8KB NAE-CW308T-STM32F1
F2 TQFP-64 STM32F215RET6 Yes Yes A 512KB 132KB NAE-CW308T-STM32F2HWC
F3 TQFP-64 STM32F303RCT7 No Yes B 256KB 40KB NAE-CW308T-STM32F3
F4 TQFP-64 STM32F415RGT6 Yes Yes A 1MB 192KB NAE-CW308T-STM32F4HWC
F4 TQFP-64 STM32F405RGT6 No Yes A 1MB 192KB NAE-CW308T-STM32F4
L4 TQFP-64 STM32L443RCT6 Yes Yes B 256KB 64KB NAE-CW308T-STM32L4 (this version has hardware crypto)
L5 TQFP-64 STM32L562RET6 Yes Yes B 512KB 256KB NAE-CW308T-STM32L5HWC

VCC-Int Supply

Several devices (F2, F4) have internal core voltage regulators. By default the CW308 board attempts to provide power for these pins, but the voltage may not be high enough to cause the internal regulator to disable itself. In this case you can use the VADJ regulator to ensure the internal regulator is disabled.

Pin-outs across TQFP Devices

The following shows differences in pinouts between three groups of devices. The left-most is the STM32F051RB, which uses the same 3.3V VCORE as the STM32F1/F3. It has fewer VCC pins, so the I/O occupying that are VCC/GND pins on the STM32F1 (such as PF6/PF7) are tied to GND/VCC. The right-most part is the pinout of the STM32F2/F4. It has an internal regulator, where the VCAP pins are the output of this regulator (and input to the internal core logic).

power_diffstm32.png

Decoupling capacitors C5/C6/C7/C8 are DNM, as they will weaken leakage on devices with a 3.3V core.

Example Projects and Using Target

Schematic